Firewire camera and PCMCIA card under Debian

Hello,
I am trying to connect a unibrain firewire camera to my T40 thinkpad
using a PCMCIA firecard. I am running debian testing and kernel 2.6.15.
The card is detected and the output of dmeg follows but the camera
doesn't even turn on and nothing happens when I connect it to the card!
Any help would be greatly appreciated.
Cheers,
Ali

> ieee1394: raw1394: /dev/raw1394 device initialized
> video1394: Installed video1394 module
> usb 2-2: new full speed USB device using uhci_hcd and address 3
> pccard: card ejected from slot 1
> ieee1394: Node removed: ID:BUS[0-00:1023] GUID[0814435800000528]
> ohci1394: fw-host0: Set PHY Reg timeout [0xffffffff/0x00004000/100]
> ohci1394: fw-host0: Set PHY Reg timeout [0xffffffff/0x00004000/100]
> pccard: CardBus card inserted into slot 1
> PCI: Enabling device 0000:07:00.0 (0000 -> 0002)
> ACPI: PCI Interrupt 0000:07:00.0[A] -> Link [LNKB] -> GSI 11 (level,
> low) -> IRQ 11
> PCI: Setting latency timer of device 0000:07:00.0 to 64
> ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[11]
> MMIO=[c4004000-c40047ff] Max Packet=[2048]
> eth1394: eth1: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
> ieee1394: Host added: ID:BUS[0-00:1023] GUID[0814435800000528]
>

-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs